Draper 19392 Manuel - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Draper 19392. Draper 19392 20 pages. 12v oscillating multi-tool
Imprimer la page
9. Maintenance and Troubleshooting
Important: Maintenance and repairs should be carried
out ONLY by authorised and suitably qualified personnel.
WARNING! ALWAYS ensure that the on/off switch (4) is
in the off (
) position and that the battery pack has
been removed before performing any maintenance on
this product.
9.1 General Maintenance
Important: Only the accessories included with this
product are replaceable by the user. Any other repair or
servicing should be carried out by an authorised Draper
Tools repair agent.
• Use only spare parts supplied by Draper Tools.
• Use this product ONLY with the recommended 12V
range battery pack and charger supplied by Draper
Tools.
− ALWAYS check the ratings plate for compatibility
before use.
• DO NOT expose the tool to rain or wet conditions.
• Keep the tool flange clean and free from obstructions.
9.3 Troubleshooting
Problem
The tool does not start when
switched on, runs slowly or loses
power during operation.
The tool flange does not close or
grip the accessory correctly.
The battery pack doesn't charge, or
the charger LED does not
illuminate.
The tool does not perform
efficiently.
• Keep all ventilation points on the tool clean and free
• Clean the product regularly using a dry cloth.
• ALWAYS remove the battery pack from the tool when
9.2 Storing the Multi-tool
• Store the product in a clean and dry location, out of
• Remove any accessories and close the tool flange
• ALWAYS remove the battery before storage.
• When stored for extended periods, charge the battery
Possible Cause
The battery pack has not been
installed or has a low charge.
There is a fault with the battery
pack.
Dust, chippings or other
obstructions are present in the tool
flange.
The pins on the tool flange are
damaged.
The fuse in the charger plug has
blown.
There is a fault with the charger.
The tool speed has not been set
correctly.
– 15 –
from dust and obstructions.
CAUTION! NEVER use aggressive chemicals to
clean the product as these may damage plastic or
insulated parts.
not in use.
reach of children.
CAUTION! Prolonged exposure to moisture can
cause the tool to rust and render it unsafe.
before storage.
periodically to maintain its health.
Remedy
Recharge and install the battery
pack.
Contact Draper Tools to discuss
replacement options.
Remove any obstructions from the
tool flange and wipe it clean.
Contact Draper Tools to discuss
replacement options.
Replace the fuse.
Contact Draper Tools to discuss
replacement options.
Test the tool speed on a scrap piece
of material similar to the workpiece
and adjust the speed as
appropriate.
EN