Draper Gen 2 Master Kit Manuel d'instructions - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Draper Gen 2 Master Kit. Draper Gen 2 Master Kit 8 pages. Front hub wheel tool
Imprimer la page
1.
PREPARING THE GEN 2 MASTER KIT
1.1 INTRODUCTION
This Front Hub Wheel tool is designed to remove the front bearing housing from the drive
flange without the need of a press.
• APPLICATION: 62mm - Audi A2, VW Lupo(front).
66mm - Skoda Fabia, VW Fox(front), VW Polo.
72mm - Audi A1, Audi A2, Seat Cordoba, Seat Ibiza, Skodia Fabia,
78mm - Ford Focus II, Ford C-Max, Volvo C30, Volvo C70, Volvo S40,
82mm - Ford Mondeo, Ford Galaxy, Ford S-Max, Land Rover Freelander 2,
85mm - VW Multivan, VW Touareg, VW Transporter(front & rear).
1.2 PRECAUTIONS
• Make sure the vehicle is securely elevated on a vehicle lift or supported with axle stands.
• Wear suitable eye protection.
• Always grease the thrust nut assembly and force screw before and after every job.
• DO NOT USE AIR TOOLS OR CORDLESS IMPACT WRENCHES WITH THIS PRODUCT.
• IMPORTANT: Do not use air tools or cordless impact wrenches on this kit. Always wear
goggles and gloves. Lubricate force screw before and after use.
• NOTE: Due to the forces involved when using this tool, the force screw must be
considered as a consumable component
• Incorrect use of this product will not be covered by our warranty.
Skoda Roomster, VW Polo(front), VW Fox with PAS(front).
Volvo V50(front), Mazda 3.
Volvo S80, Volvo V70, Volvo XC60, Volvo XC70.