Draper HG2004B Manuel d'instructions - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Draper HG2004B. Draper HG2004B 16 pages. 2000w 230v hot air gun
Imprimer la page5.
HEALTH & SAFETY INFORMATION
5.2 ADDITIONAL SAFETY RULES FOR HOT AIR GUNS
NOTE: A FIRE COULD ARISE IF THIS HOT AIR GUN IS NOT USED WITH CARE.
1.
Ensure that the hot air gun is switched OFF before connecting to the power supply.
2.
Do not use this hot air gun as a hair dryer.
3.
Do not touch the hot metal nozzle.
4.
Allow the hot air gun to cool down completely before storing.
5.
Do not direct the flow of hot air at persons or animals.
6.
Do not hold the metal nozzle too close to the work piece as the air flow will be restricted
and may cause the hot air gun to overheat. Position the nozzle at least 25mm from the
work surface.
7.
Use in a well ventilated area as poisonous or inflammable fumes or gases may be
produced from certain plastics, paints or similar materials.
8.
When working with or near easily combustible materials and inflammable gases, take
special care. (Do not apply heat to any one area for long periods of time).
9.
Heat may be conducted to combustible materials which are not visible from the
work area.
10. Never leave the hot air gun running whilst unattended.
11. Do not look directly into the metal nozzle when the machine is switched on.
12. Place the hot air gun in its free standing position (page 7) after use and allow it to cool
down before storing it away.
5.3 CONNECTION TO THE POWER SUPPLY.
Caution: Risk of electric shock. Do not open.
This appliance is supplied with a moulded 3 pin mains plug for your safety. The value of the fuse
fitted is marked on the pin face of the plug. Should the fuse need replacing, ensure the substitute
is of the correct rating, approved to Bayous and ASTA or BS Kite marked.
ASTA
BSI
The fuse cover is removable with a small plain slot screwdriver. Ensure the fuse cover is replaced
before attempting to connect the plug to an electrical outlet. If the cover is missing, a replacement
must be obtained or the plug replaced with a suitable type.
If a replacement plug is to be fitted this must be carried out by a qualified electrician.
The damaged or incomplete plug, when cut from the cable should be disabled to prevent
connection to a live electrical outlet.
This appliance is Class II
on the rating label and compatible with the plug fitted.
If an extension lead is required, use an approved and compatible lead rated for this appliance.
Follow all the instruction supplied with the extension lead.
†
Double insulated
applied to the basic insulation to protect against electric shock in the event of failure of the basic
insulation.
Important: On products exceeding 2000W it is recommended that the power cable and/or
extension cable are fully unwound before a connection is made to the power supply. However,
ensure the residual cable does not pose a trip hazard
†
and is designed for connection to a power supply matching that detailed
: This product requires no earth connection as supplementary insulation is
7