Bosch WAK24268IN Manuel d'instruction et instructions d'installation - Page 29
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et instructions d'installation pour {nom_de_la_catégorie} Bosch WAK24268IN. Bosch WAK24268IN 40 pages.
Également pour Bosch WAK24268IN : Manuel d'instruction et instructions d'installation (40 pages)
Imprimer la page
Faults and what to do about them.
Faults
Water is leaking out.
No water supply.
Detergent not dispensed.
Washing machine door
cannot be opened.
Programme does not
start.
Detergent solution is not
emptied.
Water not visible in the
drum.
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle started and
stopped several times.
The programme duration
is longer than usual.
The programme duration
changes during the wash
cycle.
Residual water in the
compartment i for care
products.
Odours in the washing
machine.
Cause/remedial action
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
■
Start/Reload A not pressed?
■
Tap not turned on?
■
Filter blocked? Clean the filter. ~ Page 26
■
Note:
If an additional water filter has been installed (depending on model)
~ Page 35, check for contaminants and clean if required ~ separate
installation and cleaning instruction for water filter.
Supply hose kinked or trapped?
■
Safety function active.
■
For safety reasons, the washing machine door remains locked when
Note:
the water level or temperature is high (See ~ Cancel the programme
~ Page 21) or while the drum is rotating.
– – – 0 (Rinse hold = without final spin) selected?
■
Can be opened by emergency release only? ~ Page 27
■
Start/Reload A pressed or Ready in ð time selected?
■
Washing machine door closed?
■
D Childproof lock activated? To deactivate: ~ Page 20
■
– – – 0 (Rinse hold = without final spin) selected?
■
Clean the detergent solution pump. ~ Page 25
■
Clean the waste pipe and/or drainage hose. ~ Page 25
■
Not a fault – water below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
because the laundry is unevenly distributed.
Distribute large and small items of laundry evenly in the drum.
Spin speed selected too low?
■
Not a fault – the unbalanced-load detection system is adjusting the imbalance.
Not a fault – the unbalanced-load detection system is adjusting the imbal-
■
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system active – adds an additional rinse
■
cycle.
Not a fault – the programme sequence is optimised for the particular washing
process. This may lead to occasional changes in the programme duration in the
display panel.
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary.
■
Run the l Drum Clean programme without laundry. Use standard detergent.
Faults and what to do about them.
en
29