Draper 1250W Instructions pour - Page 12

Parcourez en ligne ou téléchargez le pdf Instructions pour pour {nom_de_la_catégorie} Draper 1250W. Draper 1250W 16 pages. Sds+ hammer drill kit

BASIC HAMMER DRILL OPERATIONS

9.6 SDS+ SYSTEM - FIG. 5

The tool holder

without the need for a chuck key.

Pull collar

back. Insert the bit. It may be necessary to

rotate the bit to ensure it engages correctly. Release the

collar to lock the bit in place. Check by pulling the bit to

see if it's firmly seated.

IMPORTANT: Always clean and lightly grease the tool

shaft before inserting into the chuck.

Take care that the dust protection cap is not damaged.

Allowing dust and debris inside the holder will cause

problems in the future.

To remove a bit, slide the collar

out the tool.

WARNING: Bit will be hot after use.

A correctly fitted dusk mask, suitable for the activity and

in accordance to the relevant standard, must be worn.

For work activities involving exposure to fine wood dust,

a mask rated to at least FFP2 should be used.

Swarf produced by metal drilling is extremely sharp. Take

precautions when clearing swarf. The burr left on the

hole is also sharp and should be removed with a suitable

tool.

9.8 DRILLING WOOD AND PLASTIC

(Pneumatic SDS Hammer disengaged)

To prevent splitting around the drill holes on the reverse

side, place a piece of scrap timber under the material to

be drilled.

9.9 DRILLING METAL

(Pneumatic SDS Hammer disengaged)

Metals such as sheet steel, aluminium and brass may be

drilled. Mark the point to be drilled with a centre punch

to help the drill bit tip to locate. A drop of oil on area will

aid cutting and help prolong the life of the bit.

clamps SDS+ drill bits and chisels

to the rear and pull

FIG.5