Draper 36761 Manuel d'instructions - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Draper 36761. Draper 36761 20 pages. 360mm bandsaw
Imprimer la page
- 1. General Information
- 2. Table of Contents
- 3. Contents/Declaration
- 4. Specification/Guarantee
- 5. Power Supply
- 6. General Safety Instructions
- 7. Additional Safety Rules
- 8. Unpacking and Checking Contents
- 9. Getting to Know Your Bandsaw
- 10. Assembly
- 11. Operation and Use
- 12. Operation and Use
- 13. Tips on Using Your Bandsaw
- 14. Tips on Using Your Bandsaw
- 15. Maintenance/Optional Accessories
CHANGING BLADES
1. Turn the main power switch off and
disconnect from the power supply.
2. Remove front cover.
3. Remove the upper blade guard
loosen locking screw
upper support bearing
the blade (Fig.9).
4. Loosen the upper and lower blade
guide locking screws
blade guides away from the blade
(Fig.10).
5. Loosen locking screw
lower support bearing
the blade (Fig.10).
6. Using the hex key supplied
the blade tensioning bolt
to decrease the blade tension (Fig.11).
7. Remove the old blade. Slip the new
blade over the three wheels, placing
the blade as close as possible to the
centre of the wheels (make sure the
teeth face the table).
8. Turn the tensioning bolt
anticlockwise until the blade is
tensioned.
9. Rotate the idler wheel by hand until the
blade centres correctly on all three
wheels. If the blade does not track
correctly, adjust the tracking bolt
while rotating the idler wheel until it
does so (Fig.12).
10. Adjust the top
support bearings so they are just
touching the rear of the blade and lock
in place.
11. Adjust the blade guides so there is a
gap of approx. 1mm between each
guide and the blade and lock in place.
12. Reassemble the blade guard
13. Replace the front cover.
OPERATION & USE
and adjust the
away from
and move the
and adjust the
away from
turn
clockwise
and bottom blade
.
Fig.9.
,
Fig.10.
Fig.11.
Fig.12.
- 10 -