Draper 52623 Manuel d'instructions - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Draper 52623. Draper 52623 16 pages. 350mm (14") chop saw

Imprimer la page
Draper 52623 Manuel d'instructions

TROUBLESHOOTING

WARNING:
MOTOR
Trouble
Motor does not start.
Brush sparking when
released.
GENERAL
Trouble
Angle of cut not accurate.
Powerhead wobbles.
Power head will not rise
fully.
Disc binds, jams
Tool vibrates or shakes.
FOR YOUR OWN SAFETY ALWAYS TURN THE MAIN SWITCH ON THE
MACHINE "OFF" AND REMOVE THE PLUG FROM THE POWER SUPPLY
BEFORE CARRYING OUT ANY MAINTENANCE OR TROUBLESHOOTING.
Probable Cause
1. Fuse.
2. Brushes worn.
3. Other.
1. Normal - automatic brake
working properly.
Probable Cause
1. Misalignment.
1. Loose pivot points.
1. Part failure.
2. Pivot spring not replaced
properly after service.
1. Improper operation.
2. Warped disc.
1. Disc not round.
2. Disc damaged.
3. Disc loose.
4. Other.
Remedy
1. 13 amp time delay fuse or circuit
breaker.
2. See "Maintenance".
Authorized service agent.
Remedy
1. Check for worn pivot.
1. Check/replace worn parts.
1. Authorized service agent.
2. Authorized service agent.
1. See basic saw operation.
2. Replace disc.
1. Replace disc.
2. Replace disc.
3. Tighten wheel flange securing bolt.
4. Authorized service agent.
- 10 -