Draper 33826 Manuel d'instructions - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Draper 33826. Draper 33826 12 pages. 25 & 50 litre compressors

Imprimer la page

OPERATION Cont'd

4. To start the compressor turn the switch to the

ON position as shown in Fig.4.

The pressure switch is pre-set at the factory and

the compressor is also fitted with an overload

safety relief valve in the event of the pressure

switch not functioning correctly.

5. To stop the compressor turn the pressure switch

to the OFF position. Do not switch off at the

power supply before switching off at the

machine. See Fig.5.

The amount of air pressure inside the receiver

is indicated by the gauge ✭✌ Fig.5.

MAINTENANCE

IMPORTANT:

Before performing any maintenance operations,

disconnect the compressor from the power supply

and release all the air from the receiver, until the

pressure gauge reads zero.

EVERY DAY:

A. Check the oil level and top up if required with

Shell Corena P68 Monograde oil or equivalent.

B. Drain the condensate from the receiver. The

drain plug ✮✌ Fig. 6. is situated on the

underside of the receiver tank.

EVERY MONTH:

A. Clean the air suction filter using compressed

air. Replace the filter every 500 hours of use.

NOTE:- The position of the filter will vary on

each model, refer to the parts listing & drawing

of the model concerned.

B. Check the tension of the drive belt and adjust if

necessary.

EVERY 1000 HOURS:

A. Replace the oil. Remove the drain plug ✯✌

Fig.7. and drain the oil into a suitable container.

Refit the drain plug and refill the crank case

with new oil to the correct level.

B. Clean all the external surfaces of the pump unit

and motor. Ensure that neither the motor fan

cowling ✰✌ or head cooling fins ✱✌ are

blocked or obstructed in any way. See Fig.8.

EVERY 2000 HOURS:

Check the condition of the valves and replace

✮✌

Fig.6.

✱✌

- 7 -

Fig.4.

Fig.5.

✭✌

Fig.7.

✯✌

Fig.8.

✰✌