Draper Stormforce 98437 Manuel - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Draper Stormforce 98437. Draper Stormforce 98437 20 pages. Angle grinder/cut-off tool
Imprimer la page
5.
HEALTH AND SAFETY INFORMATION
Secure work. Use clamps or a vice to hold the work. It is safer than using your hands and it frees
both hands to operate the tool.
Stay alert. Watch what you are doing. Use common sense. Do not operate tool when you are
tired.
Wear proper clothing. Do not wear loose clothing, neckties or jewellery (ring, wristwatches etc.)
to catch in moving parts. Non-slip footwear is recommended. Wear protective covering to contain
long hair. Roll long sleeves above the elbow.
Use safety goggles (Head protection). Wear goggles approved to the relevant standards at all
times. Normal spectacles only have impact resistant lenses, they are NOT safety glasses. Also,
use face or dust mask if application is dusty and ear protectors during all operations.
Sound levels. Some types of machines may have high sound levels when working. In such cases
ear protection must be worn.
Vibration levels. Hand held power tools produce different vibration levels. You should always
refer to the specifications and the relevant Health and Safety guidelines.
Dust extraction. If your tool is fitted with a dust extraction facility, always ensure that it is
connected and being used with a dust extractor. Vacuum cleaners can be used if suitable for the
material being extracted.
Check damaged parts. Before use, any blade guard or other part that is damaged should be
carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting
and any other conditions that may affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorised service centre unless otherwise indicated
in this instruction manual. Have defective switches replaced by an authorised service centre. Do
not use the tool if the switch does not turn it on and off.
Have your tool repaired by a qualified person. Use of this electric tool is in accordance with the
relevant safety requirements. Repairs should only be carried out by qualified persons using
original spare parts, otherwise this may result in considerable danger to the user.
5.3
SAFETY RECOMMENDATIONS FOR THE CORRECT USE OF
ABRASIVE PRODUCTS
General. Bonded abrasive products are breakable and shall therefore be handled with utmost
care. The use of damaged or improperly mounted or used abrasive products is dangerous and can
cause serious injuries.
Delivery, handling and storage. Abrasive products must be handled and transported with care.
Abrasive products must be stored in such a manner that they are not subjected to mechanical
damaged and harmful environmental influences.
Selection of the abrasive product. Information on the label or the abrasive product stating
restrictions of use, safety indications or any other instructions must be followed. In case of doubt
concerning the selection of abrasive products, the user shall request information from the
manufacturer or supplier.
Visual inspection and ring test. Abrasive products must be subjected to a visual inspection as
received before mounting. In addition, a ring test shall be executed for vitrified wheels with
D>80mm. Damaged abrasive products shall be destroyed.
Mounting before starting and information for grinding. The mounting of abrasive products
shall be carried out according to the instructions provided by both the wheel and the machine
manufacturer. Mounting of abrasive products must be carried out by a qualified trained person.
After initial mounting, the wheel must be test run for a reasonable time – the specified maximum
operating speed of the wheel shall not be exceeded.
Further information. The following instructions must be observed, supplementary to the information
contained in the instruction for use of the grinding machine:
– 8 –