What to do if ...
Water is running out.
– Correctly attach/replace drainage hose.
– Tighten screw-fitting on the supply hose.
Water not flowing in.
–
Start/Pause not selected?
Detergent not washed in.
– Tap not open?
– Filter blocked? Clean the filter.
– Supply hose kinked or jammed?
Washing-machine door cannot
– Safety function active. Stop programme?
be opened.
–
(rinse stop = without final spin) selected?
– Can be opened via emergency release only?
Programme does not start.
–
Start/Pause or
– Door closed?
Detergent solution is not drained. –
(rinse stop = without final spin) selected?
– Clean the drain pump.
– Clean outlet pipe and/or drainage hose.
Water not visible in the drum.
– Not a fault – water below the visible area.
Spin result not satisfactory,
– Not a fault – unbalanced load detection system has stopped the spin cycle,
washing wet/too damp.
washing unevenly distributed.
Distribute small and large items of washing in the drum.
–
Reduced Ironing selected?
– Too low speed selected?
The programme duration
– Not a fault – the programme sequence is optimised for the particular wash process.
changes during the wash cycle.
This may result in changes to the programme duration in the display field.
Spin cycle actuated several
– Not a fault – unbalanced load detection system adjusts imbalance.
times.
Residual water in the dispenser
– Not a fault – effect of the care product not impaired.
for care product .
– If required, clean insert.
– Run
Odour formation in the washing
machine.
Foam is coming out of the
– Too much detergent used?
detergent drawer.
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into dispenser II
(not for outdoor, sports and down-filled textiles!).
– Reduce detergent dosage for the next wash cycle.
Loud noise formation, vibrations
– Appliance feet fixed? Secure appliance feet.
and "Wandering" during spin
– Transportation protection devices removed?
cycle.
Remove transportation protection devices.
Noises during spin and drain
– Clean the drain pump.
cycles.
Display panel/indicator lights do
– Power failure?
not function while the appliance
– Fuse tripped? Switch on/replace fuse.
is running.
– If the fault occurs repeatedly, call customer service.
The programme takes longer
– Not a fault – unbalanced load detection system adjusts imbalance by repeatedly
than usual.
distributing the washing.
– Not a fault – foam detection system active – a rinse cycle is switched on.
Detergent residue on the
– Occasionally phosphate-free detergents contain water-insoluble residue.
washing.
– Select
In the pause status
Start/
– Water level too high. Washing cannot be reloaded.
Pause flashes very quickly and a
Immediately close washing machine door.
signal sounds.
– Select
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
– Set programme selector to Off and pull out the mains plug.
– Turn off the tap and call customer service.
Page 10
Page 4
Page 3, 4
Page 6
(Ready in) time selected?
Page 3, 4
Page 10
Page 5
Page 5
Page 9
Cottons 90 °C programme without washing. Use standard detergent.
Installation Instructions
Installation Instructions
Page 10
Rinse or brush the laundry after washing.
Start/Pause to continue the programme.
Installation Instructions
Washing machine
en Operating instructions
11
Imprimer la page