Bosch 2 Manuel d'instructions original - Page 10

OBJ_BUCH-965-004.book Page 19 Thursday, August 6, 2009 2:38 PM

English | 19

Work Examples

Laying of Square Tiles (see figure A)

Position the measuring tool in a corner in such a manner that

the 0° laser line runs parallel to a wall and the T-edge 7 of the

measuring tool faces against the wall. Lay the first square tile

in such a manner that any right-angled side of the tile is seated

flush on the 0° and the 90° laser line.

Laying with Diagonal Pattern (see figure B)

Position the measuring tool in such a manner that the 90°

scale 6 faces directly against a wall. Begin with the first diago-

nal tile at intersecting point P.

Laying from Edges (see figure C)

Position the measuring tool with the L-edge 11 facing against

the edge from which on you want to lay the tiles. The 90° laser

line should run parallel to this edge. The 0° laser line now

marks the bottom tile row.

Tile laying in Kitchenettes (see figure D)

Firstly, determine the height at which the first tile row is sup-

posed to begin. Attach the measuring tool vertically to the wall

so that the 90° laser line displays the bottom edge of the first

tile row.

Keep the measuring tool clean at all times.

Do not immerse the measuring tool in water or other fluids.

Wipe off debris using a moist and soft cloth. Do not use any

cleaning agents or solvents.

Regularly clean the surfaces at the exit opening of the laser in

particular, and pay attention to any fluff of fibres.

If the measuring tool should fail despite the care taken in man-

ufacturing and testing procedures, repair should be carried out

by an authorised after-sales service centre for Bosch power

tools. Do not open the measuring tool yourself.

In all correspondence and spare parts orders, please always in-

clude the 10-digit article number given on the type plate of the

measuring tool.

Bosch Power Tools

1 609 929 T81 | (6.8.09)