Bosch 300 Series Manuel d'utilisation et d'entretien / Instructions d'installation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien / Instructions d'installation pour {nom_de_la_catégorie} Bosch 300 Series. Bosch 300 Series 40 pages. Built-in wall ovens
Également pour Bosch 300 Series : Manuel d'utilisation (40 pages), Manuel de l'utilisateur (21 pages), Manuel d'installation (6 pages), Manuel d'installation (36 pages), Manuel d'installation (32 pages), Manuel d'utilisation (50 pages), Manuel de démarrage rapide et de sécurité (7 pages), Manuel d'installation (28 pages), Manuel de démarrage rapide (7 pages), Manuel d'utilisation et d'entretien (32 pages), Manuel de démarrage rapide et de sécurité (7 pages), Manuel d'entretien (36 pages), Manuel de démarrage rapide et de sécurité (13 pages)

Imprimer la page
Bosch 300 Series Manuel d'utilisation et d'entretien / Instructions d'installation
Sink/Basin or Floor drain:
▯
If using the elbow supplied on the hose re-position
elbow closer to the drain end of hose and fasten with
the plastic ties as shown in picture "C".
Secure hose and/or elbow as shown below. Sink "D"
or floor "E".
NOTICE: Examples shown are for reference only. Not all
fittings, connectors, nuts, brackets, ties, etc. are supplied
to accommodate every application.
Maximum height of drain is 39 in. (100 cm).
14
Sink Drain Pipe:
▯
Attach and secure drain hose as shown below in
picture "F".
Use a standard hose clamp which can be purchased
from your local hardware store.
Minimum height of drain for installation shown above is
31.5 in. (80 cm). Maximum height of drain is 39 in. (100
cm).
NOTICES
Examples shown are for reference only. Not all fittings,
▯
connectors, nuts, brackets, ties, etc. are supplied to
accommodate every application.
Ensure there are no kinks or crimps along the entire
▯
length of hose.
If installed in an upper floor of a multi-story building,
▯
the dryer should be installed on a drained floor to
prevent water damage to lower floors in the event of a
leak.

Electrical Connections

Power Cord
The attached power cord is a standard 4-wire dryer cord
and is UL approved and listed in the USA and Canada. It
meets the following requirements:
208-240 volt rated (minimum);
▯
30 amps;
▯
Type SRDT or DRT (UL 2158).
▯
NOTICE: If your specific installation requires a 3-wire
power cord follow the installation instructions for such in
the next section of this manual.