Bosch 800 Series Manuel d'utilisation et d'entretien - Page 38

Warming Drawer Maintenance

Removing the Drawer

9 CAUTION

To prevent burns, do not remove drawer while hot.

Be sure drawer is empty before removing.

Removing Drawer from Housing

NOTICE: The following is the manufacturer's

recommendations for removing and installing the drawer

to minimize the risk of damage to the PTO mechanism.

Remove the drawer from the drawer housing.

Pull drawer to fully open position.

▯

Press down right drawer release lever.

▯

Lift up left drawer release lever.

▯

Firmly pull the drawer straight out.

▯

Retract cabinet rails while drawer is removed.

▯

Grasp both sides of the drawer and pulling straight

and level, carefully remove the drawer housing. This

step may require light to moderate force to completely

remove drawer.

Install or service (clean) housing with drawer removed.

English 35

Installing Drawer to Housing

The slides mounted to each side of the housing wall

have two moving components, an inner rail and a ball

bearing carrier which need to be in the proper orientation

for accurate installation and alignment.

There is also a visible locking mechanism located at the

rear of each slide.

Note: The housing of your warming drawer should

match the image below identically before starting your

installation. The ball bearing carrier should be locked in

to the inner rail's black plastic rail tip at the front of the

inner rail.