Bosch Benchmark Series Manuel d'entretien - Page 23
Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Bosch Benchmark Series. Bosch Benchmark Series 45 pages. Built-in wall ovens
Également pour Bosch Benchmark Series : Manuel d'entretien (36 pages), Manuel d'installation (32 pages), Manuel de référence rapide (4 pages), Manuel d'instructions d'installation (40 pages), Manuel de démarrage rapide et de sécurité (13 pages)
Imprimer la page
58300000181895 ARA EN A
6.3
Door Latch/Motor Assembly
The motorized door latch (MDL) mechanism (120VAC 60Hz 4.3W)
has 2 switches - the door switch and the lock/unlock switch. The latch
will automatically lock when mode and temperature selectors are set
to Self Clean, and unlock when the oven cools to ~490°F. The latch
and motor are serviced as an assembly.
Figure 29 Oven door latch
If the latch becomes stuck in the locked position, turning the unit off
and back on will open the latch if the cavity temperature <491°F. If
latch is stuck in a partially locked position, turn the mode and
temperature selectors to Self Clean, then turn them to Off.
If these measures fail, run a thin wire or wire coat hanger in between
the door and the front face of the oven. Figure 30 shows where to
position the wire between the latch hook (1) and the plunger (2). Slide
the wire to the left, pushing the latch hook left and releasing the latch.
2
1
Figure 30 Latch in locked position
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JUNE 2014
There is a Door Lock Relay Test available in Service mode. See the
Service Mode section for details.
6.3.1
1. Remove power to the oven.
2. Remove the inner screws securing the latch to the latch plate,
then remove the outer screws securing the latch plate to the oven.
Figure 31 Front latch plate; remove/replace screws in order shown
3. Hold the latch hook and slide the latch assembly a little to the left
to disengage it from the small support bracket that sits directly
behind it, then pull the latch forward.
Figure 32 Door latch/motor assembly and rear support bracket
4. Disconnect the wires.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Built-in Wall Ovens
Replacing the Latch/Motor Assembly
Page 23 of 45
800 944-2904