Bosch hbe5451uc Manuel d'installation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Bosch hbe5451uc. Bosch hbe5451uc 27 pages.
Également pour Bosch hbe5451uc : Manuel d'installation (28 pages)
Imprimer la page
Four-wire
Connection
Ungrounded
Neutral
power supply
junction
red
black wires
green or bare
wire
green wire
white wires
UL listed
connector
_
cable from
oven
o Connect the red oven wire to the red electrical supply
wire (hot wire).
o Connect the black oven wire to the black electrical
supply wire (hot wire).
o Connect the white neutral oven wire to the white
neutral (not bare or green ground) electrical supply
wire.
o Connect the green ground oven wire to the bare or
green ground electrical supply wire.
Three-wire Connection
Grounded Neutral
power supply
junction box_
red
black wires
white, bare or
UL listed
green wire
_
connector
white wire
green wire
cable from
oven
o Connect red wire from oven to red wire in junction box.
o Connect black wire from oven to black wire in junction
box..
o Connect both green ground wire and white wire from
oven to white, green or bare neutral wire in junction
box.
The conduit cable, where connected
at the oven, swivels.
Rotate conduit cable upward (or downward)
and direct
through hole prepared in cabinet to attach to junction
box.
To maintain serviceability,
the flex conduit must not be
shortened and should be routed to permit temporary
removal of the oven.
Mount to cabinet
NOTICE:
Before installing the appliance,
be sure to
verify the cabinet dimensions
and electrical connections.
Note:
The appliance
is heavy. It is advisable to install it
with a second person.
1. Fully insert the appliance
and centre it.
NOTICE:
Do not kink the connecting
cable or route it
over sharp edges.
2. Remove the rubber profiles.
3. In the holes there are plastic sleeves which are
required for fastening.
4. Secure the appliance to the cabinet using 2 screws.
5. Reinsert the rubber profiles.
Check the Installation
• ,
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
Switch on the circuit breaker.
Verify that elements function properly.