AirStage UTY-DCGG Manuel d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AirStage UTY-DCGG. AirStage UTY-DCGG 11 pages. Central remote controller
Également pour AirStage UTY-DCGG : Manuel d'installation (9 pages)

Imprimer la page
61 31

DIP Switch Setting

CAUTION
Use an insulated screwdriver to set the DIP switches.
Do not touch the DIP switch with your hands.
▪
Before using this product, always set DIP switch (SW1)-
No.1 to "ON".
If not set, when the main power is turned on again, the
set data by menu operation will be erased and cause
erroneous operation.
▪
Do not change the setting of other switches.
[DIP Switch(SW1)]
▪
Performs the enabling/disabling of the backup function
by the internal battery.
▪
It is disabled when shipped from the factory to prevent
consumption of the charge.
DIP Switch (SW1)
DIP Switch
No.
OFF
ON
1
 Disabled
Enabled
2
-
3
-
61 41

Installation Method - Integrated type

6. 4. 1
Integrated type
(1)
Pass power supply cable-A through Hole-A,
and connect it to the power supply terminal of
the power supply unit PC board.
(2)
Fix with the binder.
Power supply cable-A
Binder (accessory)
ON
OFF
1 2 3
Details
For enabling/disabling the
backup function.
Not used. Fixed to "OFF".
Not used. Fixed to "OFF".
(  :Factory setting)
Hole-A
POWER SUPPlY
L N
Power supply terminal
(3)
Open the knockouts (2 places), and install the
one touch bush (2 pcs, accessories).
(4)
Connect the connector of power supply cable-B
(accessory) to the relay connector of the cable
coming from the power supply unit PC board.
One touch bush (accessories)
knockout
Hole-B
power supply
cable -B
(accessory)
knockout
Hole-C
One touch bush
(accessories)
(5)
Pass power supply cable-B through Hole-C and
Hole-D, and connect it to rear panel terminal.
(6)
Pass transmission cable through Hole-B,
Hole-C, and Hole-D, and connect it to rear
panel terminal. Fix with the binder(accessory).
Transmission cable
Binder
(accessory)
Power supply
cable-B
Hole-C
Hole-D
(7)
Fix with the binder (accessory).
Binder
(accessory)
Power supply cable-B
Transmission cable
Rear panel terminal
Take care so that the earth (ground) cable does
not get into touch with other cables and parts.
Hole-A
Relay connector
Hole-B
Hole-A
+5V
GND
X1
X2
En-6