AirStage UTY-DCGY Manuel d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AirStage UTY-DCGY. AirStage UTY-DCGY 11 pages. Central remote controller
Également pour AirStage UTY-DCGY : Manuel d'installation (9 pages)

Imprimer la page

41 21

Installation restrictions

Make a service space to perform installation work.

Service space

WIRING RULES

Always use the accessories and specified installation

work parts. Check the state of the installation parts.

Not using the specified parts will cause fall, water leak-

age, electric shock, fire, etc.

Install at a place that can withstand the weight of the

unit and install positively so that the unit will not topple

or fall.

When installing this unit, make sure that there are no

children nearby. Otherwise, injury or electric shock

could result.

After this unit is installed, perform a test run to verify

that the device operates normally. Then describe the

operation method of this unit to the customer.

Install a circuit breaker. Not installing a circuit breaker

will cause electric shock or fire.

Before opening the case of this unit, remove all the

static electricity accumulated on the human body. It

will cause an accident.

When the front cover fixing screws are removed, be

careful that the front cover does not fall off. It will

cause an injury.

The circuit boards of this unit are at both the front

cover and rear cover. When a cover is opened, the cir-

cuit boards may be damaged by the screwdriver. This

will cause an accident.

The front cover and rear cover are connected by wir-

ing. When disassembling, be sure that the wiring is not

stretched.

Do not touch this unit's circuit board and circuit board

parts directly with your hands. Doing so may cause

electric shock or injury.

Tightening the mounting screws too tight will damage

the case of this unit.

En-3

Unit: mm (in.)

WARNING

CAUTION

51 11

Terminal names

(1)

Power supply unit

Power supply

relay connector

output : DC 5V

l,N : Power supply

1Ø AC 100-240V

Tightening torque

1.2 to 1.8 N·m (10.6 to 15.9 lbf·in)

Screw size M4

(2)

Control unit

(Rear panel side)

Power supply terminal

Power supply cable-B

Transmission cable

Tightening torque

Screw size M2.6

51 21

Wiring rules

WARNING

Before starting installation work, turn off the power of

this unit and the connection destination. Do not turn on

the power again until installation is completed. Other-

wise, it will cause electric shock or fire.

Use the accessories or specified power supply cable

and connection cables. Do not modify power supply

cable and connection cables other than those speci-

fied, do not use extension cables, and do not use

independent branch wiring. The allowable current will

be exceeded and cause electric shock or fire.

Install the connection cables securely to the terminal

block. Confirm that external force is not applied to the

cable. Use connection cables made of the specified

cable. If intermediate connection or insertion fixing are

imperfect, it will cause trouble, electric shock, fire, etc.

Power supply terminal

Power supply

L N

Earth (Ground)

Rear panel terminal

(Red)

DC +5V

(Black)

GND

(Green)

0.3 to 0.5 N·m (2.7 to 4.4 lbf·in)

DC +

GND