Alemlube 5005AN Instructions de service

Parcourez en ligne ou téléchargez le pdf Instructions de service pour {nom_de_la_catégorie} Alemlube 5005AN. Alemlube 5005AN 2 pages. Refuelling drum pump

Imprimer la page
Alemlube 5005AN Instructions de service
SERVICE INSTRUCTIONS
Description
The 5005AN refueling drum pump is designed for the transfer of fuels and lubricants up to SAE30. This economical and
hard working drum pump has a delivery rate of approximately 1 litre per stroke or approximately 40 litres per minute.
Lightweight, the pump is supplied with 2.4 metres of delivery hose, a versatile metal delivery spout and a spout holster.
The simple and proven design of the 5005AN makes this pump the ideal drum pump for fuel and lubricant transfer in
challenging and harsh operating environments.
Specifications
Use
Petrol, diesel, kerosene and lubricants up to SAE30 from 60 or 205 litre drums
Discharge Volume
40 litres per minute or 1 litre per stroke
Inlet/Outlet
Inlet: 1"BSP Outlet: 1"BSP
Hose
2.4 metres of 1"ID fuel resistant hose
Materials
Aluminium handle, aluminium body with POM piston and piston rings
Fitting the telescopic downtube to the pump
Screw the downtube to the pump, carefully applying the thread tape to the
thread on the downtube to ensure there are no air leaks between the
downtube and the pump inlet whilst securing the downtube firmly in place.
Fitting the pump to the drum or tank
1 Pull out the short tube to the fully extended position then place the pump
in the drum or tank.
2 Screw the pump to the drum or tank firmly.
Fitting the hose to the pump (Sequence Is Important)
1 Place the hose & spout in the hose holster. (The locking pin on the spout
engages in the keyway at the extreme left of the holsters opening).
2 Turn the spout fully clockwise to ensure that when fully assembled, the
nozzle locking pin rests vertically within the holster.
3 Fit the hose clamp loosely to the end of the hose and slide the spring
down onto the hose.
4 Push the hose end onto the pump outlet, slide the hose clamp over the
hose at the outlet and tighten. Slide the hose spring up against the hose
clamp. Check that the spout locking pin is still in a vertical position inside
the holster. If not, adjust the hose position on the spout to correct this.
Pump Operation
When the handle is pulled back, the piston is pushed up by the con rod and
the valve closes. At the same time fuel or lubricant on the top of the piston is
discharged through the hose. When the handle is pushed forward, the piston
is pulled down by the cross bar and the valve is opened. The fuel or lubricant
then flows past the valve through the centre of the piston and fills the cylinder
above the piston. The inlet valve is closed during this stroke.
NSW
TEL: (02) 9939 0711
FAX: (02) 9939 0411
Visit our website at
Refuelling rum Pump
VIC/T S
QLD
TEL: (03) 8787 8288
TEL: (07) 3889 8480
FAX: (03) 8787 8266
FAX: (07) 3889 8490
www.alemlube.com.au
S /NT
TEL: (08) 8241 7111
FAX: (08) 8241 7011
5005AN
W
TEL: (08) 9209 3066
FAX: (08) 9209 3933