Carlin EZ-Temp 90320 Manuel de démarrage rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Carlin EZ-Temp 90320. Carlin EZ-Temp 90320 4 pages.

Model 90320 Microprocessor Temperature Controls — Data sheet

Configurations

Mounting – 90320 controls mount to any standard well. Mount the

90320 directly to a well (new or existing) with hardware sup-

plied in the separate well mounting kit.

Well Kits – Wells for 90320 sensors are available in the sizes shown

below. Well kits include sensor mounting hardware designed to

hold sensor securely in position.

Sensors – Sensors are available separately for the 90320.

Error Codes

Error Code

Primary (K2) relay is welded on. Note: If the control is reset

from error code 01, the red LED will flash every 5 seconds

indicating the control must be replaced.

Primary & Safety relays (K1 and K2) on. The control cannot

be reset from error code 02 and must be replaced.

Primary & Safety relays (K1 and K2) are off. Note: If this

error is detected, the control will show error code 03 and

enter soft lockout two times to try and resolve the issue. If

the problem persists the control will enter hard lockout.

Simulated High Temp lockout. Push the RESET button.

Temp is above set high temp but below thermistor high

(250°F). This is a common occurrence once the burner

turns off.

1 1

Reason

Internal hardware safety failure – unit should be replaced. Contact customer service for additional informa-

tion. 1-800-989-2275

Error Code

Temp sensor 1 out of range failure. Replace sensor 1.

Temp sensor 2 out of range failure. Push the RESET button.

High limit temp sensor out of range failure. Replace the

high temp sensor.

Temp sensor 1 pin is open. Replace sensor 1.

Temp sensor 2 pin is open. Replace sensor 2.

High limit temp sensor is open. Replace the high temp

sensor.

Reason