Draytek Vigor VigorAccess Manuel de démarrage rapide - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Draytek Vigor VigorAccess. Draytek Vigor VigorAccess 17 pages. Draytek vigor vigoraccess: quick start
Également pour Draytek Vigor VigorAccess : Spécifications (2 pages)
Imprimer la page
How to Upgrade Firmware
Users can use the following commands to upgrade new firmware. Make sure you have prepared a TFTP
server on a host and put the firmware (ipdslam.all for example) in the right directory of the TFTP server
Command
Admin> system
Admin/system> upgrade <ServIP>
<FirmName>
Admin/system> reboot
Admin/system> basicInfo
How to Save Configuration
Users can use the following command to save the current configuration.
Command
Admin> commit
How to Enable/Disable the Switch Port
Users can use the following commands to enable or disable the port on Controller. By default, G1 to G6
are off, but G0 and UP-G are on. If users find that when they connect the subtend slave machines to the
master machine but the connection cannot be constructed, check the link status of the port connected to
the master machine is enabled.
Command
Admin> system
Admin/system> link_state -s
Admin/system> link_state -m <IntfName>
on/off
How to Connect to DSL Module
Users can login to DSL module in master or slave units using the following command. Once entering into
DSL module, the command described in Part II can be used.
Command
Admin> dsl
Admin> dsl –c
Admin> dsl –s m
Admin> dsl –s <slaveId>
8
Description
Enter system directory
Execute the firmware upgrading
Reboot the Controller to run the new firmware
After rebooting, check the firmware version
Description
Save the configuration
Description
Enter system directory
Display the current status of all ports
Turn on/off of the specific port
Description
Display the current connectivity with DSL modules
Login to DSL module in master via serial channel
Login to DSL modules in master via Ethernet channel
Login to DSL modules in slave via Ethernet channel
<slaveID> is "1" to "6" indicating the port the slave
device connects to
Quick Start Guide for VigorAccess