Drayton Digistat 2 Instructions pour l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} Drayton Digistat 2. Drayton Digistat 2 2 pages.

Imprimer la page

BATTERY REPLACEMENT

30 days before the batteries need

replacing, a battery symbol will flash in

the right hand side of the display,

(Diagram C). This signifies that two

1.5V type AA alkaline batteries

will be needed to replace the existing

ones. If battery replacement is carried out in this condition

the programmed settings will only be held in the memory for

a maximum of one minute, after which re-programming may

be necessary.

IMPORTANT

To avoid the possibility of having to

re-programme the switching times

and temperatures, it is advisable to

wait until the display with a flashing

battery

symbol

changes

continuous

battery

only

display

(after 30 days – Diagram D). In this condition the unit will

remain OFF but your programmed settings will be held in

memory for a number of weeks. The battery compartment

can now be left open, to replace the batteries, for

approximately one hour. If the compartment is left open for

longer, the unit will revert to the factory preset times and

temperatures. It may be necessary to reset the correct time

of day after changing the batteries.

The battery compartment is situated at the bottom of the

unit (press to unlatch and slide down). Ensure new batteries

are installed correctly.

HELPFUL HINTS

1) First/last set times

The Day 1 setting

cannot be programmed before

12.00am. The night setting

can be programmed at

whatever time you require, even after 12.00 am (midnight) so

long as it is not programmed more than 23 hours 50 minutes

after the Day 1 setting.

2) Part or full day omission

If during programming the Digistat, one of the symbols on the

left hand side of the screen starts to flash, this indicates that

two or more of the switching times have been set to the

same time. This facility enables you to omit one or more of the

switched periods. When one or more switching times are

programmed together the later setting takes precedent. For

example, if all four switching times were set together the

Digistat would control continuously at the fourth (night)

temperature setting

3) Programme sequence

Diagram C

The Digistat will not allow you to program the switched

periods out of sequence but will hold the times together as

stated above.

4) Reset

If at any time during the programming you get confused and

would like to start the procedure from the beginning press the

SELECT and – buttons at the same time and hold for two

seconds. This resets the Digistat to the factory pre-set times

and temperatures shown in the table (overleaf).

5) Self revert

If during programming no button is pressed for between one

Diagram D

and two minutes the Digistat will revert automatically to its

normal operating mode.

CONFORMS TO THE ESSENTIAL

REQUIREMENTS OF THE FOLLOWING

DIRECTIVES:

89/336/EEC

– Electromagnetic compatibility

73/23/EEC

– Low voltage directive

Siebe Climate Controls Limited

Chantry Close, West Drayton, Middlesex UB7 7SP

Telephone: (01895) 444012 Sales Fax: (01895) 421901

Technical Helpline Telephone: (01895) 460444

A Siebe Group Product

Siebe Climate Controls reserve the right to make changes without notice and

cannot accept liability for errors.

Drayton

Digistat 2

User instructions

090 678

0898