Drayton Lifestyle LP241Si Instructions pour l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} Drayton Lifestyle LP241Si. Drayton Lifestyle LP241Si 20 pages. Central heating control
Également pour Drayton Lifestyle LP241Si : Instructions d'installation (2 pages), Instructions de service (2 pages)
Imprimer la page
I
If you don't want to alter either day, keep pressing SET?
until the programmer goes back to normal operation.
If the engineer has set your program and timings – you
won't need to do anything else. Just keep this guide in a
safe place for future reference.
INTRODUCTION
Lifestyle Programmers will automatically switch your central
heating and hot water on and off at times that suit you.
Depending on your system, central heating and hot water
can either both come on and off at the same time, or work
independently. The red light on the front of the programmer
shows when each one is on.
INTRODUCTION Cont...
There are 3 models in the Lifestyle range:
I
LP241Si – a 24hr program, with central heating and hot water
SAT-SUN
working independently for up to 3 heating periods each day, and
7.00am
every day the same.
I
9.00am
LP522Si – a 5/2-day program allowing for different timings at
the weekends, with central heating and hot water working
12.00pm
independently for up to 3 heating periods each day.
12.00pm
I
LP722Si – a 7-day program allowing for different timings on
4.00pm
each day of the week, with central heating and hot water
11.00pm
working independently for up to 3 heating periods each day.
If the engineer hasn't set your timings for you, your programmer
will work with a standard program that has been set at the
factory. If this doesn't suit you, it's very easy to change it –
when you've read this introductory section, simply go to the
section that contains your programmer model.
Remember:
I
Make your changes using the SET?, YES/-, and + buttons on
the programmer.
I
You can't set ON1 as the last timing before midnight, but you
can set OFF3 after midnight – providing it's not more than 23
hours and 59 minutes after ON1.
I
You need to set the timings in sequence – i.e. ON1, OFF1, ON2,
OFF2, ON3, OFF3. If you get out of sequence, the display will
flash a warning.
User's Instructions
PROGRAMMERS
SWITCHING
THE LP241Si 24hr ELECTRO
LP241Si – a 24hr program
working independently for
and every day the same.
If the timings haven't been
will still be on the factory-s
central heating and hot wa
same timings for every day
changes, and have heating
– just follow the instruction
Want to leave a timing as i
the next one.
If you need to reset your tim
and start again, press 'SET
the pre-set program.
If you don't press anything
automatically goes back to