Drazice OKC 200 NTRR / BP Manuel d'utilisation et d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} Drazice OKC 200 NTRR / BP. Drazice OKC 200 NTRR / BP 18 pages. Stationary water heaters
Également pour Drazice OKC 200 NTRR / BP : Manuel d'utilisation et d'installation (17 pages), Manuel d'utilisation et d'installation (12 pages), Manuel d'utilisation et d'installation (19 pages), Manuel d'utilisation et d'installation (20 pages), Manuel d'utilisation et d'installation (20 pages), Manuel d'utilisation et d'installation (20 pages), Manuel d'utilisation et d'installation (18 pages), Manuel d'utilisation et d'installation (13 pages)

2 OPERATION AND FITTING INSTRUCTIONS

The appliance shall only be used in accordance with the conditions specified on the

performance plate and in instructions for electric wiring. Besides legally acknowledged

national regulations and standards, also conditions for connection defined in local electric

and water works have to be adhered to, as well as the installation and operation manual.

The room, in which the appliance will be operated, must be frost-free. Temperature in the

appliance installation location must not exceed +2 °C. The appliance has to be mounted at a

convenient place, it means that the appliance must be easily available for potential

necessary maintenance, repair or replacement, as the case may be.

We would like to emphasise that the appliance must not be connected to power supply if

work involving flammable liquids (petrol, spot remover) or gases, etc., is performed

nearby.

If water is strongly calcareous we recommend that any of the common decalcifying devices

was installed with the appliance, or the thermostat to be set to minimum operation

temperature of 60

used. To avoid potential sediments we recommend that the device was installed together

with a water filter.

Prior to mounting, check the loading capacity of the wall and, depending on the type

of masonry, choose a suitable anchorage material, or reinforce the wall, if needed.

The appliance shall only be mounted in vertical position so that the lower edge

of the heater was placed at least 600 mm above the floor (Figure 1). In combined heaters,

elbows have to be attached to the heating water inlet and outlet and, by turning them,

the mounting either from the right or from the left has to be determined (Figure 3).

With regard to various types of carrying masonry and broad assortment of special anchorage

material available at the market, we do not provide appliances with this material.

The anchorage system has to be selected individually, depending on the conditions.

We recommend an authorised company perform mounting on the wall and anchorage,

or discuss the anchorage with a professional.

C. For proper operation, drinkable water of adequate quality shall be

- 8 -