ANCEL S1000 Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} ANCEL S1000. ANCEL S1000 5 pages. Automotive diagnostic leak detector

Imprimer la page

C - Smoke Outlet Port

While set up the unit, the Smoke Delivery Hose need to be mounted onto the Smoke Outlet .

D - Power Socket

While set up the unit, the power cords need to plug into the power socket.

E,F - State Indica�on and Air Control

The <E - LED Indication> LED has two states.

RED: Power ON.

GREEN: Pressurized air produc�on.

While power up the unit, the LED would turn RED.

Press <F - Air Control switch>, the <E - LED Indication> would turn GREEN, and the unit start

to generate pressurized air.

Press <F - Air Control switch> again any�me, the <E - LED Indication> would turn RED, and

the unit stops genera�ng pressurized air.

G,H - State Indica�on and Smoke Control

The <G - LED Indication> LED has three states.

OFF: Smoke genera�on not started.

GREEN: Smoke genera�on.

RED: Overheat.

While not smoke the unit, the LED would be OFF.

Press <H - Smoke Control switch>, the <G - LED Indication> would turn GREEN, and the unit

start to generate smoke.

Press <H - Smoke Control switch> again any�me, the <G - LED Indication> would turn OFF,

and the unit stops genera�ng smoke.

While the smoke genera�ng chamber is overheat, for protec�on, the smoke genera�on

would be halted and the <G - LED Indication> would turn RED and restart genera�ng smoke while

the smoke genera�ng chamber cooled down, or you can switch it OFF by pressing <H - Smoke

Control switch> .

I - System Pressure Gauge

The Pressure Gauge displays the output pressure of the machine if block the smoke outlet port,

otherwise it shows the real �me pressure of the system been tes�ng.

Pressure Decay Test: This gauge can also be used to determine if a leak exists by switching oﬀ the

<F - Air Control> while the system is under pressure. If the gauge holds the displayed pressure,

there is no leakage. If the displayed pressure starts drops, there is leakage in the system.

J - Flow Meter

The purpose of the ﬂow meter is to provide a quick visual indica�on of the amount of air/smoke

passing through the system being tested. If the smoke nozzle is in a closed system, and there are

no leaks in that system, the ﬂow meter will read zero (ball at bo�om of scale). As the system is

ﬁlled with air or smoke, the ball in the ﬂow meter will slowly fall to the bo�om of the scale as the

pressure in the system equalizes to the output pressure of the unit. As the ﬂow decreases, the

output pressure will increase. If the ﬂow meter ball never falls to the bo�om of the scale, there is

leakage or air passing through the system. It is not necessary to use smoke when using the ﬂow

meter to determine if a leak exists.

K - Flow Dial

In many cases excessive smoke exi�ng a leak may make it diﬃcult to determine the exact loca�on

of the leak. The purpose of the Flow Control Valve is to decrease the amount of smoke exi�ng a

leak so that its posi�on may be pinpointed without the masking eﬀect of excessive smoke. Turn

clockwise to decrease ﬂow, counterclockwise to increase ﬂow. This valve is also used to lock out

the system under test and observe any pressure decay on the pressure gauge.