Bosch 11335K Manuel d'utilisation et de sécurité - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et de sécurité pour {nom_de_la_catégorie} Bosch 11335K. Bosch 11335K 28 pages. Operating instructions
Également pour Bosch 11335K : Manuel de référence rapide (25 pages), Manuel d'utilisation et de sécurité (33 pages)
Imprimer la page
BM 1619929713 04-07
A
NOTCH
(Bosch internal
locking steel)
TOOL
RETAINER
LEVER
180 º
ROCKER "ON/OFF" SWITCH
TO TURN THE TOOL "ON" depress the
dust-protected switch to the number "I"
position.
TO TURN THE TOOL "OFF": depress switch
to the number "0" position (Fig. 1).
For low temperatures, the machine reaches
the full impact rate only after a certain time.
This start-up time can be shortened by
striking the chisel in the tool against the floor
one time.
VIBRATION CONTROL HANDLE
While working, hold the tool with both hands
by the handle. The handle can move upward
and downward around its axis by approx. 30
mm. This has a damping effect against
vibrations (Fig. 4).
The tool may be switched on with either
hand. Balance the tool with both hands and
rest the tool on the hip.
For the best penetration rates in concrete,
run the tool with a steady pressure, but do
not use excessive force as this will decrease
4/6/07
4:10 PM
Page 8
FIG. 3
BOSCH INTERNAL
LOCKING STEEL
SHANK END
TOOL
HOLDER
RETAINER
LEVER
Operating Instructions
"TOOL TIPS"
TOOL
For the highest possible impact damping,
work only with moderate pressure.
the efficiency of the tool. Start chipping with
the tool in a straight in position until the
surface to be broken is chipped. Draw the
hammer back at an angle of 60˚ with the
surface to be broken. Apply only enough
force to keep the tool weight on the
accessory
-8-
SHANK END
TOOL
HOLDER
FIG. 4
VIBRATION
CONTROL
HANDLE