Bosch 1615EVS Manuel d'instruction - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Bosch 1615EVS. Bosch 1615EVS 33 pages. Plunge router

Imprimer la page

Extension Cords

• Replace damaged cords immediately. Use of

damaged cords can shock, burn or electrocute.

• If an extension cord is necessary, a cord with

adequate size conductors should be used to

prevent excessive voltage drop, loss of power

or overheating. The table below shows the

correct size to use, depending on cord length

and amperage rating on the tool's nameplate. If

in doubt, use the next heavier gauge. Always

use U.L. and CSA listed extension cords.

Ampere Rating (shown on nameplate)

2.1-

3.5-

2.0

3.4

5.0

25'

50'

75'

100'

150'

Note: The smaller the gauge number, the larger

the wire is in the cord.

"SAVE THESE INSTRUCTIONS"

Operating the Tool

Trigger Switch and "Lock-On" Button

Your tool can be turned "ON" or "OFF" by

squeezing or releasing the trigger. Your tool is

also equipped with "Lock-ON" button located

just above the trigger that allows continuous

operation without holding the trigger .

TO LOCK SWITCH ON: Squeeze trigger,

depress button and release trigger.

TO UNLOCK THE SWITCH: Squeeze trigger

and release it without depressing the "Lock-

ON" button.

WARNING!

if the "Lock-ON" button is con-

tinuously being depressed, the trigger cannot be

released.

WARNING!

Hold the tool with both hands

while starting the tool, since torque from the

motor can cause the tool to twist.

Variable Speed with Dial Setting

(1615EVS)

Your router is also equipped with a variable

BM 3609929671 1/95

speed dial 21. The router bit speed can be preset

from 12,000 to maximum nameplate RPM by

rotating the dial to the desired setting. The dial

may be set on or between any of six positions (1

= low through 5 = high). The "Lock-ON"

button may also be used with any setting of the

dial.

The following speeds generally apply, but pre-

cise settings are largely determined by

experience with the material being cut. Mo-

mentary speed variation is normal when starting

the router until the electronic regulator takes

control.

5.1-

7.1-

12.1-

Dial Setting

7.0

12.0

16.0

(12,000

15,000 RPM)

12 Wire Gauge

(16,500

19,000 RPM)

"Soft Start" Feature (1615EVS)

The router is equipped with the "soft start"

feature which gradually increases the starting

speed and torque, reducing the stress that oc-

curs from a high torque start.

Start the tool before applying to work and let

the tool come to full speed before contacting

the workpiece. Lift the tool from the work

before releasing the switch. DO NOT turn the

switch "ON" and "OFF" while the tool is under

load; this will greatly decrease the switch life.

Router Bit Installation and Removal

WARNING

from the power supply before installing router

bits, accessories or making any adjustments.

Turn the armature shaft to align the flats with

the spindle lock 10, and push in with thumb to

hold the armature shaft firmly. Next, use the

27mm wrench supplied to loosen the collet

chuck assembly 7 in a counter-clockwise direc-

tion (viewed from under the router). Insert the

shank of the router bit into the collet chuck as

Material

1-3

Hardwoods, soft plastics,

nonferrous metals,

larger diameter router

bits and cutters.

4-5

Softwoods, plastics,

counter tops, smaller

diameter router bits and

cutters.

Always disconnect the tool

Installing a Router Bit

12/7/98, 11:56 AM