Advanced Industrial Computer XC-23D1-SA10-0-R Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Advanced Industrial Computer XC-23D1-SA10-0-R. Advanced Industrial Computer XC-23D1-SA10-0-R 6 pages. 2-3 sas/sata ii hdd canister

Imprimer la page
SATA Connectors
Standard 7Pin SATA connector to link to MB or HBA card.
HDD Fail LED Input
Pin Number
1
2
3
4
For some HBA supporting HDD Fail LED's. If used, the jumper is used to connect to
cathode of the diode for HDD Fault output from HBA.
It's left to open, as default, when HBA doesn't support it.
Fan Connectors
Pin Number
Description
1
2
3
A 3-pin fan connector with failure detection
4
Description
GND
HDD 0 Fail Input
HDD 1 Fail Input
HDD 2 Fail Input
GND
+12V
Tach

CHAPTER 2 INSTALLATION OVERVIEW

Warning：Before you remove or install the unit, make sure the unit is not turned on or
connected to the AC power.

2.1 Removing the HDD Tray from the enclosure

1. Press the latch to the right by the thumb.
2. Pull the tray door outward by the forefinger at the same time.
3. Remove the HDD tray from the enclosure
4. Install the four mounting screws to secure the drive in the disk tray.
5. Slide the tray into a slot. Press the tray handle until the latch is closed and locks into
place.
5
Bottom view of HDD tray