Anchor ETI 30’CLASSIC FRAME TENTS Manuel d'instructions de montage - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} Anchor ETI 30’CLASSIC FRAME TENTS. Anchor ETI 30’CLASSIC FRAME TENTS 8 pages.

Imprimer la page

30'

CLASSIC FRAME TENTS

CROSS BRACING

IMPORTANT: Cross Bracing Tubing and Fittings are supplied with the tent framing and must first be in place

before raising the tent on the legs.

For stability and to prevent frame bowing,

solid interior bracing using 14'4" x 2"

Cross Brace Tubing and Fittings need

to be installed between each opposing

16'1/4" Mid-Rafters. Start at one end along

the longer side and install as many cross

braces as there are mid-rafters.

COVER ATTACHMENT

Roll out a large drop cloth next to the assembled frame to protect the cover from dirt and abrasion.

10.

Lay out two-piece covers with lace edges together and top side up.

Matching centerlines, start in the center by pushing the first lacing

loop up through the corresponding grommet. (See diagram) Continue

lacing process and tie off last long lacing loop. Cover lacing with

protective flap and secure the hook-n-loop closure. Repeat lacing

procedure on the opposite side.

11.

Loosely pull the cover over the frame. Check the corners, hip areas and crowns to make sure the cover is

positioned correctly on the frame. Temporarily strap the cover at the corners and side (if required) of the frame

to keep any wind from catching the cover.

ADDING LEGS AND LIFTING

12.

Lay out the (7'-9') Adjustable Legs at each Corner Fitting and at each Mid-Rafter Fitting location. Leave

the adjustable Legs at the shortest length. Starting at the two corners of the longer side of the frame, two

installers should lift the corner Legs to their vertical position. Then together lift the entire side of the tent frame

and insert the Corner Fittings onto the corner Legs until the snap button engages. (Do not lift one corner at

time; lift the entire side of the tent.) Insert Legs into the side Mid-Rafter Fittings along the same elevated side

until the snap button engages.

13.

Repeat the above procedure for inserting the Legs on the opposite side of the frame. Then insert Legs into the

side Mid-Rafter Fittings along the shorter side until the snap button engages.

ASSEMBLY INSTRUCTIONS