Anchor F3 Manuel d'instructions d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Anchor F3. Anchor F3 16 pages. Frame tent
Imprimer la page
General Notes:
•
The installation manual describes in a methodical manner the assembly and erection of the Anchor frame tent. Please
read all instructions before the installation or removal of this product.
•
Installer must determine the number of persons and the proper equipment required for each installation.
•
Work from step to step.
•
Before erecting any tents or membrane structures, fi rst obtain permits and approvals as required from the local building
and fi re code offi cials on the jurisdiction of your installation.
PLEASE PAY SPECIAL ATTENTION TO SAFETY WARNINGS AND CAUTIONS FOR PREVENTION
OF ACCIDENTS.
Regarding the contents of the installation manual:
The illustrations and photos are made to show clearly the construction and dismantling procedures and also for identifi cation
of the components. Not all illustrations/photos correspond to the actual dimensions and size. Explanations and/or notes have
been added to these illustrations/photos.
If you have questions, please call your sales representative at the phone number listed on the front or back of the manual.
Safety Notes:
•
Please read through the installation manual completely before beginning your installation. Be sure the proper equipment
and safety precautions are in place.
•
Consult your local utility locator service or the National Utility Locating Contractors Association (NULCA) prior to
installation.
•
Prior to actual tent assembly, be sure to look up, down, above & below for obstacles, pipes, wires, trouble, etc.
•
Be alert to avoid contact of frame sections with any overhead power lines near the site.
•
Keep site clear of debris to avoid tripping, especially while carrying frame parts or bundles of fabric.
•
When moving frame sections by hand, use proper lifting techniques to protect the back, and avoid pinching fi ngers while
making hardware connections.
•
The installation method described in the installation manual requires coordination of tasks between workers. A safe instal-
lation is dependent on that coordination. Work cooperatively as a team.
•
Be sure all pins and bolts are installed and secured correctly during assembly.
•
Ensure that all push buttons are fully engaged at all frame/weldment connections.
•
Replace damaged or worn components with original Anchor components. Failure to use original Anchor components may
void product warranties.
•
To prevent injuries, wear suitable protective clothing such as hard hats, steel toed shoes, etc.
•
Do not drag bundle of fabric on concrete, asphalt, or ground as this can cause damage to the fabric from abrasion through
the bag.
•
Installation supervisors must take responsibility to instruct all installers about possible dangers before installation and
erection begins.
•
This tent is manufactured for use as a temporary structure. Evacuation is recommended if threatening or windy weather
occurs. See caution on back page of this manual.
•
Anchor recommends a factor of safety of at least 2X be used to resist all loads.
3