Anchor NAV50-1204 Manuel de l'utilisateur - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Anchor NAV50-1204. Anchor NAV50-1204 18 pages. 50’ wide frame tent system

Imprimer la page

UNITS WITH (2) OR MORE MID BAYS

MIDDLE BEAMS THAT ARE NOT A PART

OF AN END MODULE USE THE HINGED

BASEPLATE (FOR PIVOTING TO VERTICAL).

FIXED PLATES ARE STAMPED "END" AND

SHOULD BE USED ONLY ON END MODULES.

X-CABLED BAYS

X-CABLING FROM EAVE TO BASE-

PLATE (AS SHOWN) ON BOTH

SIDES OF THE STRUCTURE

STAKE PLATES AT PROPER SPACING BEFORE

INSTALLING THE X-CABLES. THEN, ADJUST

TURNBUCKLES UNTIL CABLE IS SNUG

ADDITIONAL GUIDE BARS

CAN BE PURCHASED

IN UNITS WITH MULTIPLE MIDDLE BAYS, THE SEC-

OND HIP END MODULE CAN BE ASSEMBLED AT

THE SAME TIME AS THE FIRST (OR LATER AFTER

THE MIDDLE BEAMS HAVE BEEN INSTALLED).

FOR MOST EASE, MAKE CONNECTIONS

IN THE ORDER SHOWN IN EACH BAY.

WHEN FRAME IS COMPLETE, MID

PANELS ARE INSTALLED THE SAME AS

PREVIOUSLY SHOWN IN THE SINGLE

MID BAY CONFIGURATION.

NAVI-TRAC UNITS 100 FT OR MORE IN LENGTH

MUST HAVE AN X-CABLED BAY NEAR THE MIDDLE

OF THE UNIT AND/OR EQUALLY SPACED) FOR

EVERY 100 FT UNIT OF LENGTH.

SUBSTITUTE BOLTS FOR PINS AT THE TOP

OF BOTH UPRIGHTS. THREADS SHOULD

POINT INWARD TOWARD EACH OTHER.

THREAD CABLE EYE NUTS ONTO EACH

BOLT TO SECURE THE CABLE.

REMOVE NUTS FROM THE BOLTS THAT PIN

THE BASEPLATE TO THE UPRIGHT. TURN

BOLTS SO THE THREADS ARE TO THE INSIDE

(FACING EACH OTHER). THREAD CABLE EYE

NUTS ONTO BOLTS TO SECURE THE CABLE.

15-T

15-B