Anchor Navi-Trac LT/CS Manuel d'instructions d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Anchor Navi-Trac LT/CS. Anchor Navi-Trac LT/CS 16 pages. Pavilion 12' to 24' projection

Imprimer la page
Step 6 - Fabric
Ends Installation
•
With one installer at
top of the end rafter,
feed eave end of
kedar into top chan-
nel opening of ridge
weldment and down
into rafter until end
of kedar reaches
the end of the rafter.
(Figure 6a)
•
Raise bottom end of
back kedar up until
bottom of kedar can
be fed down into
top of channel on
Upright Rear Upper
Splice. (Figure 6b)
•
After end fabric is in
place, fi esta buckles
on inside of fabric at
eave must be con-
nected. Slide kedar pieces with d-ring into top/outside
channel of eave beam. Align these with corresponding
fi esta buckles. Slide web through d-ring as shown in
fi gure 6c. Tighten webs.
•
End Fabric is installed.
End Fabric
Rafter
Rafter
Bottom end of
back kedar
Kedar
feeding
down into
channel
Kedar piece
with D-ring
Figure 6a
End Fabric
Figure 6b
Fiesta Buckle at-
tached to inside of
end fabric. (Fabric
not shown.
Figure 6c
12