Anchorlift Mako 1500 Manuel d'utilisation et d'installation - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} Anchorlift Mako 1500. Anchorlift Mako 1500 16 pages. World class windlass system
Imprimer la page
8
Parts & Maintenance
ITEM DESCRIPTION
1
Chain pipe cover
2
Pin
3
Pressure finger
4
Spring
5
Base
6
Base bolt
7
Rope fork (2 styles)
8
Cover bolt
9
Key
10 Gypsy shaft
12 Clip - 1
13 Bearing
14 Clip - 2
15 Oil seal
16 Washer
17 Clutch cone
18 Gypsy
19 Gypsy top cap
20 Capstan
22 Clutch handle
Basic maintenance and cleaning needs to be performed to keep this unit working properly:
Recurring: Any salt deposits must be removed to avoid corrosion and damage to the equipment. Wash thoroughly with
fresh water after each use. Polish the unit to prevent staining using auto polish or stainless steel cleaner.
Once a year: Remove the top cap and gypsy and perform required maintenance:
Use the handle (22) to remove the Gypsy Top Cap (19). Remove the top Clutch Cone (17), loosen the Cover bolts (8) on the
Chain Pipe Cover (1) and remove both parts. Pull away the Pressure Finger (3) from the Gypsy (18) and remove the Gypsy.
Remove bottom Clutch Cone (17).
Clean all the parts to prevent corrosion and grease the Shaft (10) and Gypsy (18) where the clutch cones seat (17).
Use suitable marine grease ONLY! Reassemble following the instructions and drawings above.
MAKE SURE THE ELECTRICAL POWER TO THE MOTOR IS SHUT OFF WHEN WORKING ON THE WINDLASS.
1
2
3
4
5
6
CAREFULLY REMOVE THE CHAIN OR ROPE FROM THE GYPSY.
22
8
7
WARNING
TM
19
17
18
17
16
15
14
12
13
12
10
9
www.anchorlift.com