Formax AutoSeal FK Series Manuel de l'opérateur - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Formax AutoSeal FK Series. Formax AutoSeal FK Series 18 pages.
Également pour Formax AutoSeal FK Series : Manuel de l'opérateur (12 pages)

Imprimer la page

TROUBLESHOOTING

C. Paper is not folding square (Skewing):

Figure 10

D. Machine plugged in, no power

1. Turn machine ON.

2. Make sure top cover is installed properly.

3. Press the circuit breaker (Figure 9).

4. Check wall outlet.

5. Remove operator cover check the fuse located on control board next to transformer.

6. Check all electrical connections.

E. Double feeding / Mis-feeding

1. Clean feed wheel, using soap and water.

a. Check center in-feed roller and singulator pad for wear. Replace pad if it is cupped.

b. Check to see if center in-feed roller is centered on the gate tip.

2. Run a stack of plain paper. This is done to check on proper feeding. If double-feeding does

not occur on the paper:

a. Check to be sure pressure seal forms are not sticking together. Jogging or hand

separating may be necessary to determine this.

b. Hand separate about 50 forms, align and test-run the forms. If no double feeding

occurs, proper forms handling is necessary.

1. If paper pulls left or right adjust the skew. Turn

the skew adjuster, located under the infeed tray,

(Fig. 10) left or right until the paper is feeding

correctly.