Formax FD 676 Manuel de l'opérateur - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Formax FD 676. Formax FD 676 18 pages.

Imprimer la page
6. Set up tear bar as before. (Fig. 9)
7. Set up Stacker Wheel Assembly as
before. (Fig. 6)
8. Jog first form into Sequence Stacker
to make sure that stacker wheels are
just ahead of leading edge of form. Put
urge roller in place.
9. Close Safety covers. Machine is now
ready to burst and imprint. Press start
Button and adjust machine speed to
speed desired.

OPERATING HINTS

1. To stop the machine just push on either one of
two stop buttons. Opening safety cover or lifting jam
detection grill will also stop machine.
2. To restart machine start button must be pressed.
CAUTION: Machine will restart at same speed that it
was running at unless speed control thumbwheel is
turned down.
3. Some paper has a natural curve. Sometimes this
curve tends to catch air and sail. If this occurs, try
running them upside down.
4. Perforations vary in strength. If forms are bursting
hard, tearing, or breaking behind tear
bar, vary form length setting up to 1/2"
ahead or behind actual form size setting,
and/or put tear bar in low position.
5. Multiple part forms with hard glued
edging can be burst by positioning tear
bar over glued edge.
6. Stacker wheel should not stop the
form until form clears snap rollers.
7. Carbonized forms will generally stack
better when run with coated side up.

TROUBLESHOOTING

Feeding, bursting, and stacking problems are usually
due to improper adjustment of machine to forms of
due to a non-standard or defective form.
Most problems fall into one of three categories,
Electrical, Mechanical, or Form Flow. Electrical
troubles are USUALLY obvious because machine will
not run or respond in a normal manner to its controls.
Mechanical problems are usually accompanied
by noise, slippage, tearing, or binds. If a form flow
problem is present, jamming, mis-stacking, or
intermittent form damage will occur. Problem should
be diagnosed to one of three categories, before
proceeding to pinpoint problem. Best approach is a
logical elimination of possible malfunctions.
10