Forme Studio Manuel - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Forme Studio. Forme Studio 16 pages.

Imprimer la page

S T U D I O | S A F E T Y I N F O R M A T I O N + N O T I C E S

SAFETY INFORMATION

Read all instructions before using the Studio. It is the owner's

responsibility to inform every user of the Studio of the safety

warnings and precautions.

Consult a physician before beginning any new fitness

program. If you experience chest pain or shortness of breath,

stop exercise immediately and reach out to your healthcare

provider.

The FORME Studio requires professional installation. Do

not attempt to install, uninstall, or relocate your Studio

without the help of an approved FORME installer.

The Studio warranty will be voided in the case of

self-installation.

We need to add the sentence about voided warranty in

case of self-install, unless we dropped it on purpose,

since we are not allowing threshold deliveries anymore.

Do not install the Studio outside. It is designed for indoor

use only. Always keep the Studio away from water, moisture,

or damp environments.

Do not cover FORME Studio with a blanket or any covering.

Excessive heating can occur and cause fire, electric shock,

or injury to persons. Additionally, do not hang towels or

clothing on the Studio.

Connect the Studio to a properly grounded outlet. Improper

connection of the equipment grounding conductor can result

in a risk of electric shock. Check with a qualified electrician

or service professional if you are in doubt as to whether the

product is properly grounded. No adapter should be used

with this product.

Do not allow children under the age of 18 to use the Studio

or its accessories without supervision. You are responsible

for the safety of your children and anyone else you allow to

use your FORME Studio.

Keep the power cord away from heated surfaces.

Never operate the Studio if it has a damaged cord or plug,

or if it was dropped into water. Do not operate if air openings

are blocked with lint, hair or the like. Do not operate where

aerosol (spray) products are being used or where oxygen is

being administered.

If you need to unplug the Studio, hold the power button

on the right side of the screen for four seconds until the

display turns off, then turn off the main power switch.

You can then safely unplug the Studio.

Before each use, inspect the Studio for any signs of damage

or wear. If you believe anything is out of the ordinary, do not

use the Studio. Do not attempt to repair anything on the

Studio on your own.

FORME tracks certain metrics during a workout (heart rate,

caloric burn, etc.). These are to be meant to be general

indicators and may be inaccurate.

The Studio does not have the ability to support user input

devices such as a keyboard, mouse, or touchpad.

Do not lean on the Studio mirror.

California Only (lithium coin cell): Perchlorate Material –

special handling may apply, See www.dtsc.ca.gov/hazard-

ouswaste/perchlorate

NOTICES

This device complies with FCC part 15 FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference and

2. This device must accept any interference, including

interference that may cause undesired operation

of the device.

Changes or modifications not expressly approved by the

party responsible for compliance could void the user's

authority to operate the equipment.

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more

of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment

and receiver.

- Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV

technician for help.

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment.

Responsible Party:

Interactive Strength Inc.

9854 National Blvd

Los Angeles, CA 90034

Unique Identifier: FORME Life, Model FLSS-1000

Contains FCC ID: PD99260NG