Ancona Comfort 6 Manuel d'installation et d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Ancona Comfort 6. Ancona Comfort 6 5 pages. Orb wall plug-in

Imprimer la page
Installation cont'd
Step 3: Marking holes for wall mount posts (fig. 3)
Take towel warmer with 4 wall legs mounted, as per step 2
-
Position against the wall where you will want to install the towel warmer
-
Ensure that the electric plug will reach nearest outlet.
-
Use light pencil to mark legs on the wall (you may want to erase the pencil mark following
-
installation completion, so make sure you mark lightly)
Step 4: Installing wall posts (fig. 4)
If installing on dry wall with no rear beam support:
-
o
Drill a hole in the center of each of the 4 circles marked on the wall as per step 3
o
Ensure drilled hole is large enough to insert the plastic plug provided – part a)
o
Insert / screw the plastic plug in each of the 4 holes
o
Position wall post b) on top of plastic plug and put in screw c) to set in place
If installing on surface with rear support, e.g. wood studs
-
o
Pre-drill small hole in the center of each circle as per step 3
o
Position wall post b) on top of pre-drilled hole and put in screw c) to set in place
Step 5: Mounting main body onto wall (fig. 5)
Take main body and position each of the 4 legs on top of the wall posts b)
-
Once inserted use Allen key to tighten each set screw g)
-
The installation should be complete
-
Step 6: Power the towel warmer
-
Remove protective white covers, they are located at the end of each vertical bars
Turn the switch on to start towel warmer; the on-off switch is located at the end of one of the
-
posts
The towel warmer should reach its pre-set temperature in approximately 15 minutes
-
This towel warmer is designed to operate continuously and can be left on all the times. To save
-
electricity it can be turned off when not in use.
Fig. 3
Fig. 4
Fig. 5