Forms + Surfaces SUMMIT BIKE RACK Instructions d'installation
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Forms + Surfaces SUMMIT BIKE RACK. Forms + Surfaces SUMMIT BIKE RACK 3 pages.
Imprimer la pageSUMMIT
TM
MATERIALS INCLUDED
7/32" hex bit for
tamper-resistant
screws
epoxy
STEP BY STEP
FOR ALL SURFACE MOUNTED SUMMIT BIKE RACKS
Mark hole locations
• Place bike rack in desired location. Mark
center of each hole location with a
pencil.
T 800.451.0410 | www.forms-surfaces.com
© 2014 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
BIKE RACK
TOOLS NEEDED
a
b
c
1/4", 1/2" & 3/4" drill
Drill holes
• Use hammer drill to drill 4.5" deep x 3/4"
diameter anchor hole at each marked
location using a 3/4" drill bit suitable for
concrete drilling.
NOTE: Forms+Surfaces recommends
starting holes with 1/4" diameter drill
bit followed by 1/2" and finally 3/4" for
maximum accuracy.
pencil
bits for concrete
hammer drill
SURFACE MOUNT INSTALLATION INSTRUCTIONS
steel
wire brush
epoxy gun
Fill holes & insert anchors
• Use compressed air and steel wire brush
to clean each anchor hole in accordance
with epoxy instructions.
• Use epoxy in epoxy gun to fill each anchor
hole 5/8 of the hole depth in accordance
with epoxy instructions.
• Insert 3/8"-16 x 4-1/4" epoxy anchor
(a) into each anchor hole so anchor top
is flush with ground. Allow proper curing
time according to cure schedule on epoxy
instructions before moving on to Step 4.
Loctite
a
page 1 of 3 | Rev. 05-19-14