Carmanah E Series Manuel d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Carmanah E Series. Carmanah E Series 20 pages. Rrfb mast arm kit
Également pour Carmanah E Series : Manuel de démarrage rapide (20 pages), Manuel d'installation (16 pages), Manuel de remplacement du système de gestion de l'énergie (12 pages), Manuel de l'utilisateur (18 pages), Manuel de remplacement (9 pages), Manuel d'installation (18 pages)

Discard

leftover

wire

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | [email protected] | carmanah.com

Prepare AI Harness

If the AI Integration Kit was ordered with a

Carmanah E/F system, skip to step 15.

• Obtain AI harness.

• Cut and remove terminals of the five wires shown

(violet, blue, black, red and yellow).

• Leave green wire ring terminal intact (not shown).

• Cut yellow wire to same length as black wire.

• Cut a three-inch section of yellow wire and strip each

end 0.35", for use later.

• Install provided heat-shrink tubing around the five wires

4.25" from end of black wire (other wires will end up

being longer).

• Use heat gun to affix the heat shrink tubing.

• Strip insulation of the five wires 0.35".

APPLIED INFORMATION (AI) INTEGRATION KIT INSTALL GUIDE

E/F Series

4.25"

Page 7