Forms+Surfaces HELIO BOLLARD Instructions d'installation et de câblage - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et de câblage pour {nom_de_la_catégorie} Forms+Surfaces HELIO BOLLARD. Forms+Surfaces HELIO BOLLARD 4 pages.

Imprimer la page

HELIO

BOLLARD

™

STEP BY STEP

FOR ALL SURFACE MOUNT HELIO BOLLARDS

11-13mm

(0.47in.)

Locate and prepare wires

Note: Installation should be performed only

by qualified individuals.

• Before proceeding with wiring of luminary,

check to ensure that all applicable site

wiring and safety codes have been

followed.

• Locate wires at base of light fixture.

• Ensure power supply is shut off and circuit

being used is isolated.

• Prepare wiring from site junction box and

bollard by stripping and removing

11-13mm (.47") of insulation.

Note: Wire used should be 22-14 AWG

copper conductors.

Caution: Installation of a surge protector as

part of each unit's wiring is recommended.

T 800.451.0410 | www.forms-surfaces.com

© 2021 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.

SURFACE MOUNT WITH J-BOLTS INSTALLATION & WIRING INSTRUCTIONS

Connect wires

• Insert ground (green), neutral (white), and

positive (black) wires into provided wire

nuts, being sure to match wire color

codes from junction box to bollard.

• Tighten wire nuts until exposed wire ends

are below bottom of wire nut.

• Inspect all wiring and connections before.

Caution: Light fixture rated for 120-277

VAC power.

Place bollard

• Slide bollard over base plate, lower and

align mounting holes.

page 3 of 4 | Rev. 05-25-21