Carmanah G Series Manuel d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Carmanah G Series. Carmanah G Series 14 pages. Rrfb mast arm kit
Également pour Carmanah G Series : Manuel de démarrage rapide (16 pages), Manuel (11 pages), Manuel de remplacement du système de gestion de l'énergie (12 pages), Manuel de remplacement des portes d'armoires (10 pages), Manuel (9 pages), Manuel de l'utilisateur (18 pages), Manuel (10 pages), Manuel (10 pages), Manuel d'installation (18 pages)

Carmanah G Series Manuel d'installation
4. Apply Loctite 220 threadlocker to two standoffs.
5. Assemble standoffs to the inside of the cabinet using two security screws and two flat washers.
6. Fasten the long wire from door switch to slots with two cable ties. Leave loose/untrimmed for now.
7. Install door switch to the standoffs using two screws, two lock washers, and two flat washers.
8. Center switch front/rear in slots and tighten. No Loctite threadlocker is required for this step.
The terminal on the end of the long door switch wire gets installed into the Applied Information
(AI) harness connector in a later step.
9. Install ring terminal from door switch onto top Battery/DC Power RD + fuse holder terminal.
10. Install two cable tie bases as shown below. Fasten the long wire from door switch to the two cable tie
bases. Leave loose/untrimmed for now.
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
APPLIED INFORMATION (AI) INTEGRATION
INSTALL GUIDE
9
|
carmanah.com