CommScope 760082560 Instructions de montage - Page 5
Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} CommScope 760082560. CommScope 760082560 5 pages. 4-post equipment rack
Imprimer la page
4.
Raise the frame to an upright position.
5.
Using a carpenter's square, align the vertical rack
rails, extruded top angles and extruded base
angles to square.
6.
Tighten all bolts securely.
7.
Completed frame may be installed onto floor
attachments forward, center or to the rear using
the extruded base angle.
Installation
Note: Racks are approved for mounting on concrete or other non-combustible surfaces.
1. The equipment rack must be securely anchored to the floor or to an equally stabilized and secure
surface using approved mounting hardware
2. The structural integrity of the rack will only be as good as the quality of the rack to floor attachment.
Using improper sized anchors or failing to secure all floor bolts can result in structural failure and
possibly personnel injury.
3. Racks tend to be top heavy and as such should be anchored as soon as possible to avoid the
possibility of tipping over. Never install equipment until the rack is fully locked down and secured
to the floor.
860421239
Issue 5, March 2013
Page 5 of 5