Formula Sound FF2.2 Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Formula Sound FF2.2. Formula Sound FF2.2 15 pages.

Operational Information

Starting

Unpowered, turn over the FF2.2, a silk screen legend indicates the position of various additional

controls that are to be preset before use.

Set cartridge capacitance for phono inputs to your preferred setting to best match the cartridge

using a small flat bladed screwdriver, there are 4 settings, through the hole by the legend for

cartridge capacitance the slotted shaft of a switch should be visible, place the screwdriver blade

into the slot and lightly turn to the position you require. If in doubt turn to one end and then count

clicks until you are at position.

If you require rumble filters they are enabled by a switch through the hole by the legend indicting

rumble filter, push the blade of the small flat blade screwdriver through the hole and activate the

switch if you require the rumble filter on, the switch is on when depressed and to switch it off

gently press it again and it will click off. In the off position the switch cap is nearer the case (higher)

and on the switch cap is lower.

If you are using a microphone and it requires phantom power, the phantom power switch is by the

legend phantom power, push the blade of the small flat blade screwdriver through the hole and

activate the switch if you require the phantom power on, the switch is on when depressed and to

switch it off gently press it again and it will click off. In the off position the switch cap is nearer the

case (higher) and on the switch cap is lower.

If you require your mic in the booth signal, the mic in/out of booth switch is by the legend mic

in/out of booth, push the blade of the small flat blade screwdriver through the hole and activate the

switch if you require the mic in the booth (switch on), the switch is on when depressed and to

switch it off gently press it again and it will click off. In the off position the switch cap is nearer the

case (higher) and on the switch cap is lower.

If you require the booth set to mono, the booth mono switch is by the legend booth mono, push

the blade of the small flat blade screwdriver through the hole and activate the switch if you require

booth mono (switch on), the switch is on when depressed and to switch it off gently press it again

and it will click off.

If you require a mono output instead of sub bass, the sub bass/mono switch is by the legend sub

bass or mono, push the blade of the small flat blade screwdriver through the hole and activate the

switch if you require mono (switch on), the switch is on when depressed and to switch it off gently

press it again and it will click off.

If you require the cross fader to be switched off, the cross fader off switch is by the legend X Fade

on/off, push the blade of the small flat blade screwdriver through the hole and set the switch to off

(cap higher), switch is on when depressed (lower) and to switch it off gently press it again and it

will click off.

The remaining presets through the base of the unit require the FF2.2 to be active to set (booth

pan, mic gain and mic EQ), so now return the FF2.2 to correct way up.