ATI Technologies Q46H/64 Manuel de communication - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de communication pour {nom_de_la_catégorie} ATI Technologies Q46H/64. ATI Technologies Q46H/64 18 pages.
Imprimer la page
ATI
Q46 Ethernet/IP Communications Manual
1.5
Cable Connection
The cable used for Ethernet/IP communication should meet the CAT5 standard
defined by the Electronic Industries Association and Telecommunications
Industry Association. It is readily available in lengths up to 100 ft. (30 m) with
plugs on each end.
To install an Ethernet cable in the Q46, pass the unterminated cable through the
cable gland nearest the location of the RJ45 connector on the Ethernet/IP option
board. Termination of Cat5/5e/6 cables is very easy and can be completed
quickly with the commonly available RJ45 crimp tool.
While professional results are optimized with the use of the termination tool and
custom cable lengths, patch cord style connection can be completed in some
cases by passing the finished RJ45 connectors through the Q46 cable gland.
The connector will fit through the plastic part of the cable gland, and the rubber
grommet can be slit (some RJ45s may be too big for this.) Once the connector is
inside the enclosure, simply plug it into the jack provided on the Ethernet/IP
communication board. Be sure to adjust the rubber insert in the cable gland so
that the slit is on the bottom and then tighten the gland to seal around the wire.
Figure 2 - RJ45 Crimp Tool
6