ATI Technologies QC-201 Manuel - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ATI Technologies QC-201. ATI Technologies QC-201 17 pages. Tool changer

Imprimer la page
Manual, Tool Changer, QC-201
Document #9620-20-B-201 Base Tool Changer-12

5. Troubleshooting

Symptom
Check these conditions prior to
any further troubleshooting.
Unit will not lock or unlock

6. Recommended Spare Parts

Assembly
Master Plate
Locking Mechanism
Tool Plate

Pinnacle Park
1031 Goodworth Drive
Ensure that the Quick-Change has proper pneumatic and
electrical connections, air is supplied at a minimum of 60psi
(4.1 Bar), that no air or vacuum can be trapped in a de-
energized Lock or Unlock Port (pressure must be vented to
atmosphere).
Check air supply
Verify that ball bearings are moving freely. Clean and lubricate
as needed to restore smooth operation (see
Maintenance
Verify the control module is operating correctly.
Verify that the Master and Tool are within the specified No-
Touch zone when attempting to lock.
Part Number
9120-201NM-0000-0000-
0000
8590-9909999-08
9005-20-1060
3410-0001066-01
3410-0001065-01
3410-0001068-01
3700-20-1452
3700-20-1453
9120-201M-Seals
3700-20-3209
3700-20-1381
3410-0001041-01
3410-0001042-01
9120-201NT-0000-0000-
0000
3490-0001016-01
3700-20-3207
Apex, NC 27539
Tel: 919.772.0115
B - 14
Possible Cause / Correction
).
Description
Complete QC-201 Master Plate, No Options
PNP Proximity Sensor
Alignment Pin Assembly
6mm x 2mm Buna O-ring
14mm x 2mm Buna O-ring
U-Cup
Check Valve
Valve Stem
Master Seal Kit for QC-201/202
Male coupling
Ball bearing, 15 mm
O-ring, JISA-P90, dynamic ring upper piston
area
O-ring, JISA-P22, dynamic ring lower piston
area
Complete QC-201 Tool Plate, No Options
G3/8 Brass Plug
Bearing Race
Fax: 919.772.8259
www.ati-ia.com
Section 4—