Andersen 82-3ST Manuel du produit - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} Andersen 82-3ST. Andersen 82-3ST 12 pages.

11. Apply grease to the gearwheels and teeth. Put these gear sets aside for the moment and

proceed with the next step.

12. Main Drive Gear Set Service

The main drive gear set (1) contains the clutch that engages and disengages to provide 3rd

gear or 1st gear operation when turning the winch handle in a clockwise direction. Remove

it from the winch base as a complete unit before disassembly.

a. The overdrive gear positioned at the top of the gear set can

be lifted off and cleaned. Check for wear on the gear teeth

and bearing surfaces. Set the overdrive gear aside and

proceed with the next steps.

b. Turn the lower part of the gear set upside down and remove

the 8 screws that hold it together. Lift off the closing plate

and the freewheel gear to expose the bronze pawl carrier.

Remove and clean the pawls and springs, checking the pawls

and pawl pockets for wear. With normal use these pawl

springs should be changed every two years or so.

c. Turn over the pawl drive assembly and separate the drive

gearwheel from the bronze pawl carrier to access the

springs that control the gear shifting torque. Lift out and

clean the springs; check the 4 angled sliders for wear.