Andersen 400 Series Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Andersen 400 Series. Andersen 400 Series 6 pages. Lock mechanism
Également pour Andersen 400 Series : Manuel d'installation et de retrait (2 pages), Ajustement (4 pages), Manuel de modification (2 pages)
Imprimer la page
Parts Included
(1) Sill Gusset Plate
(1) Head Gusset Plate
(5) Non-Reinforced Mullion Clips
(3) Non-Reinforced Mullion Alignment Spacers
(1) Vertical Exterior Trim Piece
(10) 1" Screws
(20) 1-3/8" Flat Head Screws
Tools and Supplies
• Safety Glasses
• Hammer
• Electric Drill
• 3/32" Drill Bit
• Phillips Head Screwdriver
• Caulk Gun
• Sealant
• Putty Knife
• Utility Knife
1. Prepare and Join Units
Remove any excess adhesive along side jambs being
joined with putty knife to prevent inadequate join.
• Place units side by side, interior side up on a clean flat
work surface.
• Remove Installation Flange from side jambs being joined.
• Select one unit for attaching Non-Reinforced Mullion
Alignment Spacers and Vertical Exterior Trim Strip.
• Locate Alignment Spacers into unit's Side Jamb
Joining Dado at top, bottom and center of side jamb,
tacking in place with 1/2" staples or nails.
• Apply a 3/16" bead of sealant, full length to both sides
of Vertical Exterior Trim Strip leg, as illustrated below.
• Place Vertical Exterior Trim Strip, tapered end at sill,
into unit's flange groove. Vertical Exterior Trim Strip
must be flush at ends.
Non-Reinforced Joining Guide (Vertical)
Components
Vertical Exterior
Trim Strip
Sill Gusset Plate
Non-Reinforced
Mullion Alignment
Spacer
Head Gusset Plate
Side Jamb
Joining Dado
Non-Reinforced
Mullion Alignment
Spacer
Vertical
Exterior
Trim Strip
Vertical Exterior
Trim Strip
Sealant
2
Non-Reinforced
Mullion Clip
1" Screw
Sill
Interior Sides Up
3/16" Diameter
Sealant Bead
1-3/8"
Screw