Bosch 900947 Instructions pour l'utilisation et l'assemblage - Page 40
Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisation et l'assemblage pour {nom_de_la_catégorie} Bosch 900947. Bosch 900947 48 pages. Clothes dryer
Imprimer la page
de Troubleshooting
disturbance
Pumping noise.
Whirring sound.
Drying time is too
long.
Water is leaking out.
40
Cause and troubleshooting
Condensation pump active.
Not a fault - normal operating noise.
▶
Compressor ventilation active.
Not a fault - normal operating noise.
▶
The bottom unit filter is dirty.
→
"Cleaning the filter system of the base unit ",
▶
page 31
The fluff filter is dirty.
→ "Clean the fluff filter ", page 29
▶
Ambient temperature is higher than 30 ° C.
Make sure the ambient temperature is below 30 ° C.
▶
Ambient temperature is lower than 15 ° C.
Make sure the ambient temperature is above 15 ° C.
▶
Insufficient air circulation at the place where the device is
installed.
▶
Ventilate the place where the device is installed.
The air inlet to the device is blocked.
Make sure that the air inlet of the device is kept
▶
clear.
The heat exchanger is dirty.
→ "Open the bottom unit ", page 34 .
1.
Clean the heat exchanger.
2.
→
"Cleaning the base unit ", page 34
→ "Closing the base unit ", page 36 .
3.
Device is not aligned correctly.
Align the device
▶
The seal of the heat exchanger cover is contaminated.
Clean the seal on the heat exchanger cover.
▶
→
"Cleaning the filter system of the base unit ",
page 31
The lever of the heat exchanger cover is not closed
correctly.
Make sure that the lever on the heat exchanger
▶
cover is properly closed.
→ "Closing the base unit ", page 36