Anderson ANM75 Manuel d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Anderson ANM75. Anderson ANM75 18 pages.

The air and fuel mixture inside the burner are controlled by air wing design and gas nozzles

to optimize emissions and efficiency.

ANM75 series burner are modular design, can assembled from straight sections to various

shape, allowing for customized heat inputs. Blower connects with burner air duct to

provide combustion air with correct air flow and pressure. Brackets are available for slot

firing or duct mounting and flanges are available for continuous flange mounting. Gas flow

is controlled by gas control valve. Ignition can be by direct spark or by ignition pilot. Flame

rod supervision can be from either one end or both ends. Combustion air flow (DP) switch

and process air DP switches are factory mounted on the burner.

ANM75 Series Burner Advantage:

– An integral combustion air blower can be ordered mounted on the back of the burner,

to provide combustion air.

–

Stable operation over a wide range of duct velocities from 1.5m/s to 30m/s without

installing a profile plate around the burner.

–

High turn down ratio to 40:1 to match different requirement.

–

The modular design, length of each module is 300 mm. Output of each module can

get as high as 300KW, different modules can be installed with shape of line shape, "I"

shape, "T" shape or "+" shape according to customer requirement.

–

Only 10% excess air is needed when burner run at high fire.

–

Reliable operation performance, once commissioning is complete, it is stable under

same condition, no need extra adjustment or maintenance.

–

Burner suit for different gas fuel such as natural gas, LPG or hydrogen.

6. Burner Component Introduction

75ANM series burners are mainly made up of air wings, gas channel, peripheral fixing

device and connecting devices. Air wings were fixed by rivets, different components are

connected together with rivets or bolts to form the Burner body. Shown as below Fig 1 is

exploded drawing view, in which the air wing and outer connectors are made of stainless

steel, gas channels and connectors are cast iron.

Anderson Thermal Soluions（Suzhou）Co. ,Ltd.

Anderson Thermal Solutions – ANM75 Burner Operation Manual

Fig 1. ANM75 Series Burner Explosion View