Community Controls Monarch 300MCP21KC Manuel - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Community Controls Monarch 300MCP21KC. Community Controls Monarch 300MCP21KC 2 pages.
2 - NUMBERING
Each transmitter is manufactured and sold with a different factory- set serial
number .
3 - PROGRAMMING
The transmitter must be programmed into your system memory.
Your own installer or reseller will provide you the necessary instructions for your
system.
4 - OPERATION
A - Firmly depress the button until the small red LED illuminates.
B - After the LED has illuminated, release the button.
If the device you are attempting to activate does not respond, repeat steps A and B
or consult section 6 ( Troubleshooting ) of this manual.
5 - BATTERY ACCESS
To access the battery open the case with a screwdriver acting on the slot between
the cover and the bottom and remove the bottom, as shown in fig. 3a and 3b.
Slide out the old batteries and replace them with the new ones [CR2016]
respecting the polarity, with the positive (+) side facing up.
NOTE : Please dispose of the batteries properly according to local laws and
regulations.
Test proper battery installation by verifying that the red LED illuminates when the button
is pushed.
Fig. 3a
BATTERY STATUS
Battery level
Led color
Led GREEN
Normal level
Led ORANGE
Attention level
Led RED
Low level
Fig. 3b
TX Status
~6000 pulses [*] - Normal range
Max 300 pulses
[*]
- L ow range
Replace battery - No range
The CR2016 lithium batteries of the transmitter have a shelf life of
about 6 months.
The product fully complies with Part 15 of FCC Regulations and
the European Directives 99/5/CE, 89/336/CEE, 73/23/CEE .
1B - Technical specifications
Operating frequency
Number of keys:
Battery :
Battery life:
Number combinations :
Operating temperature:
Overall dimensions:
W eight:
1C - Main components
Red
LED
Light grey
case
Fig. 2
300 MHz
1
2 x 3V lithium batteries CR2016
18 ÷ 24 months
1024
-20°F÷+131°F (-20°C÷+55°C)
2.4"x1.4"x0.51" (61x36x13 mm)
0.49 oz. (14 gr.)
Grey
push-button
Key
ring
holder