Community Controls MONARCH 295SEPC1K Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Community Controls MONARCH 295SEPC1K. Community Controls MONARCH 295SEPC1K 2 pages.

Imprimer la page

2 - NUMBERING

Each transmitter is manufactured and sold with a different factory-set serial

number .

3 - PROGRAMMING

The transmitter must be programmed into your system memory.

Your own installer or reseller will provide you the necessary instructions for your

system.

4 - OPERATION

A - Firmly depress the button until the small red LED illuminates.

B - After the LED has illuminated, release the button.

If the device you are attempting to activate does not respond, repeat steps A and B

or consult section 6 ( Troubleshooting ) of this manual.

5 - BATTERY ACCESS

To access the battery open the case with a screwdriver acting on the slot between

the cover and the bottom and remove the bottom, as shown in fig. 3a and 3b.

Slide out the old batteries and replace them with the new ones [CR2016]

respecting the polarity, with the positive (+) side upward.

NOTE: Please dispose of the batteries properly according to local laws and

regulations.

Test proper battery installation by verifying that the red LED illuminates when

the button is pushed.

Fig. 3a

Fig. 3b

6 - TROUBLESHOOTING

PROBLEM

The system does not receiver the

transmitter signal.

The transmitter LED will not light

The system does not receiver the

transmitter signal.

The transmitter LED is ON

The operating range is reduced

Community Controls - Type : 295SEPC1K

FCC ID : SU7295SEPC1K

This device complies with

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept interference received, including

interference that may cause undesired operation.

Any changes or modification to

approved by

Community Controls

The warranty period of Community Controls 295 transmitters is 60 months,

beginning from the manufacturing date of the transmitter. During this period, if the

product does not operate correctly, due to a defective component, the product

will be repaired or replaced at the sole discretion of Community Controls.

The warranty does not extend to the transmitter case which can be damaged by

conditions outside the control of Community Controls or to battery life.

SOLUTION

Replace the transmitter

batteries

Check to verify the

transmitter is programmed

into your system

Replace the transmitter

batteries

Part. 15 of the

FCC Rules

Notice

Community Controls

equipment not expressly

could void the manufacturer's warranty.

WARRANTY

COMMUNITY CONTROLS

2500 South 3850 West, Suite A

Salt Lake City, UT 84120

(800) 284-2837 - (866) 867-3637 Fax